FORWELL PRECISION MACHINERY CO., LTD.
About Us Video News Service E-catalog Contact Us Home
 
Worldwide Q & A Contact Us

 

 
 
1. No display in the control panel ?
Ensure that power switch is in the ON position.
 
 

 

 
 
2. Control panel display is normal but system will not operate ?
Ensure that the sliding switch between the two-point set is open.
 
 

 

 
 
3. Pump runs continuously ? (an no signs of leaking fluid)
Check fluid level indicator to see if fluid is too low, if level is normal,turn the relcase valve to let out some of the air in the pressure line.
 
 

 

 
 
4. Clamp does not hold die securely ?
Ensure that the thickness of the die base is within the specifications for the clamp.(Die base may be too thin)
 
 

 

 
 
5. Clamp does not hold die sccurcly ?
Turn off die lifter so that lower die clamp can return to normal operation.
 
 

 

 
 
6. Die lifter dies not rise ?
Turn off lower die clamp so die lifter will return to normal operation.
 
 

 

 
 
7. Air pressure is insufficient and hydraulic pressure too low ?
Check to see that compressor is turned on and air lines are free and clear, if there are no problems with the air supply, inspect the air pressure regulator on top of the two-point set and adjust the pressure as needed.(Check first to see if PU hose is ruptured or damaged)
 
 

 

 
 
8. Unusually slow pumping action (the voice of the pump is very slow)
Internal lubrication pump
 
 

 

 

 

FORWELL PRECISION MACHINERY CO., LTD.

No.399, Sec. 2, Mingsheng Rd., Pusin Township, Changhua County 513, Taiwan.
Tel: +886-4-8345196  Fax: +886-4-8345197  E-mail: forwell@forwell.com  http://www.forwell.com   Skype Me™!
Copyright © FORWELL PRECISION MACHINERY CO., LTD. Hosted by Machinetools Directory (S & J Corp.), Plastic and Rubber Machine Directory.