Forwell Die Cart and Mold Cart System, Die Cart, Shuttle Mold-Carts, Mold Carts, Die Carts

The Core of The Power - Forwell Quick Die Change
Main Products

Die / Mold Cart System

Die Cart, Shuttle Mold-Carts, Mold Carts - Pressure Clamps

Pressure Clamps

The Die / Mold Cart System uses pneumatic type pressure clamps to securely clamp the mold in place. These Pressure Clamps are movable across the plate for suitable positioning and allow for repeatable, high pressure clamping with less distortion on equipment resulting in longer die and mold life. Forwell’s clamps can adapt to almost all configurations of dies and molds and are available in four different models depending on the clamping force required.
 

Specifications

Die Cart, Shuttle Mold-Carts, Mold Carts - Specifications
 
Model TFH-10 TFH-16 TFH-25 TFH-40
Clamping Farce 98 157 245 310
Fixed pressure (kN)

0.39MPa Air pressurea

98 157 245 310

0MPa Air pressure

26.5 40.9 65 83
Clamping force (kN)

0.49MPa Air pressure

75.5 124 190 258

0.39MPa Air pressure

63.7 104 160 235

0MPa Air pressure

14.7 23.5 35 52
Full stroke (mm) 2.8 3 3.3 4
Clamping stroke (mm) 1.2 1.2 1.3 1.5
Safety stroke (mm) 1.6 1.8 2 2.5
Cylinder capacity (cm)3 Clamping 773 1334 2468 4250
Release 729 1262 2346 2780
Pressure (MPa) (MPa)Air pressure 0.49
(MPa)Air pressure 0.39
Work temperature 70°C
Using frequency 20/日

Dimensions

Model E FA FB FC G J K L MA MB
TFH-10 156 135 95 130 48 19 164.5 299.5 119 115.5
TFH-16 182 142 104 160 55 23 203 360 128 132
TFH-25 227 170 130 190 65 25 253 434 158 167
TFH-40 247 200 146 210 80 25 253 454 170 178
 
 
Model N P MIN.Q R S T U W X Z H
TFH-10 8.5 11 163.5 3 98.5 13 32.5 36 M12 6 40±0.3
TFH-16 12 13 203 5 100.5 17 40 30 M20 6 40±0.3
TFH-25 12 17 245 5 125.5 20 50 37 M24 10 50±0.3
TFH-40 15 17 255 5 145.5 27 60 37 M30 20 50±0.3

 

 

Press Machine | Injection Molding | Hydraulic Pumps